U-Boot> U-Boot> run nfs.boot dm9000 i/o: 0x30000000, id: 0x90000a46 DM9000: running in 16 bit mode MAC: 00:12:34:56:78:94 operating at 100M full duplex mode TFTP from server 10.1.1.5; our IP address is 10.1.1.236 Filename 'AT_ARM/_AT_uImg'. Load address: 0x22000000 Loading: ################################################################# ############################################### done Bytes transferred = 1637164 (18fb2c hex) ## Booting kernel from Legacy Image at 22000000 ... Image Name: Linux-2.6.24 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1637100 Bytes = 1.6 MB Load Address: 20008000 Entry Point: 20008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Uncompressing Linux......................................................................................................... done, b ooting the kernel. Linux version 2.6.24 (duyky@duyky-ubuntu) (gcc version 3.4.5) #5 Sat May 12 17:41:41 PDT 2012 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 Machine: SBC9261 Ignoring unrecognised tag 0x54410008 Memory policy: ECC disabled, Data cache writeback On node 0 totalpages: 16384 DMA zone: 128 pages used for memmap DMA zone: 0 pages reserved DMA zone: 16256 pages, LIFO batch:3 Normal zone: 0 pages used for memmap Movable zone: 0 pages used for memmap Clocks: CPU 198 MHz, master 99 MHz, main 18.432 MHz CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets CPU0: D cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 Kernel command line: console=ttyS0,115200 root=/dev/nfs rw nfsroot=10.1.1.5:/home/duyky/_NFS/AT_RFS,wsize=1500,rsize=1500 ip=dhcp ig nore_loglevel debug: ignoring loglevel setting. AT91: 96 gpio irqs in 3 banks PID hash table entries: 256 (order: 8, 1024 bytes) Console: colour dummy device 80x30 console [ttyS0] enabled Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 64MB = 64MB total Memory: 61488KB available (2996K code, 253K data, 120K init) Calibrating delay loop... 98.91 BogoMIPS (lpj=494592) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok net_namespace: 64 bytes NET: Registered protocol family 16 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered NetWinder Floating Point Emulator V0.97 (double precision) JFFS2 version 2.2. (NAND) B) 2001-2006 Red Hat, Inc. yaffs May 12 2012 17:38:06 Installing. io scheduler noop registered io scheduler anticipatory registered (default) atmel_lcdfb atmel_lcdfb.0: 150KiB frame buffer at 23d40000 (mapped at ffc00000) Console: switching to colour frame buffer device 40x30 atmel_lcdfb atmel_lcdfb.0: fb0: Atmel LCDC at 0x00600000 (mapped at c485c000), irq 21 atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL atmel_usart.2: ttyS2 at MMIO 0xfffb4000 (irq = 7) is a ATMEL_SERIAL RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize dm9000 Ethernet Driver eth0: dm9000 at c485e000,c4866004 IRQ 56 MAC: 00:12:34:56:78:94 Driver 'sd' needs updating - please use bus_type methods NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit) Scanning device for bad blocks Creating 7 MTD partitions on "NAND 128MiB 3,3V 8-bit": 0x00000000-0x00020000 : "bootstrap" 0x00020000-0x00060000 : "uboot" 0x00060000-0x00080000 : "env1" 0x00080000-0x000a0000 : "env2" 0x000a0000-0x001a0000 : "logo" 0x001a0000-0x003a0000 : "kernel" 0x003a0000-0x08000000 : "rootfs" atmel_spi atmel_spi.1: Atmel SPI Controller at 0xfffcc000 (irq 13) TSC2301 driver initializing input: TSC2301 keypad as /class/input/input0 input: TSC2301 touchscreen as /class/input/input1 tsc2301 gpio initializing usbmon: debugfs is not available ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver at91_ohci at91_ohci: AT91 OHCI at91_ohci at91_ohci: new USB bus registered, assigned bus number 1 at91_ohci at91_ohci: irq 20, io mem 0x00500000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. mice: PS/2 mouse device common for all mice evbug.c: Connected device: "TSC2301 keypad", spi1.2/input-kp evbug.c: Connected device: "TSC2301 touchscreen", spi1.2/input-ts input: gpio-keys as /class/input/input2 evbug.c: Connected device: "gpio-keys", gpio-keys/input0 i2c /dev entries driver rtc-rx8025sa 0-0032: clock needs to be set rtc-rx8025sa 0-0032: rx8025sa found, am/pm, driver version 0.5 rtc-rx8025sa 0-0032: rtc core: registered rtc-rx8025sa as rtc0 i2c-gpio i2c-gpio: using pins 39 (SDA) and 55 (SCL) at91sam9_wdt: invalid timeout (must be between 1 and 16) AT91 MMC: 4 wire bus mode not supported - using 1 wire Registered led device: led0 Registered led device: led1 usbcore: registered new interface driver usbkbd drivers/hid/usbhid/usbkbd.c: :USB HID Boot Protocol keyboard driver usbcore: registered new interface driver usbmouse drivers/hid/usbhid/usbmouse.c: v1.6:USB HID Boot Protocol mouse driver Advanced Linux Sound Architecture Driver Version 1.0.15 (Tue Nov 20 19:16:42 2007 UTC). ASoC version 0.13.1 check spi driver tsc2301: TSC2301 Audio Codec 0.2 asoc: TSC2301 <-> at91-ssc1 mapping ok ALSA device list: #0: sbc9261 (TSC2301) TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 RPC: Registered udp transport module. RPC: Registered tcp transport module. rtc-rx8025sa 0-0032: hctosys: unable to read the hardware clock eth0: link down Sending DHCP requests .<6>eth0: link up, 100Mbps, full-duplex, lpa 0xCDE1 ., OK IP-Config: Got DHCP answer from 0.0.0.0, my address is 10.1.1.11 IP-Config: Complete: device=eth0, addr=10.1.1.11, mask=255.255.255.0, gw=10.1.1.1, host=10.1.1.11, domain=, nis-domain=(none), bootserver=0.0.0.0, rootserver=10.1.1.5, rootpath= Looking up port of RPC 100003/2 on 10.1.1.5 Looking up port of RPC 100005/1 on 10.1.1.5 VFS: Mounted root (nfs filesystem). Freeing init memory: 120K << Start rcS for System Start-Up>> /opt/apache/bin/apachectl start: httpd started Start ntpd to get / set time Thu Jan 1 00:00:15 UTC 1970 << Done rcS >> << Start Shell Profile >> << Done profile >> arm_11:/home %