U-Boot > U-Boot > run nfs.boot Using device TFTP from server 10.1.1.5; our IP address is 10.1.1.122 Filename '_uImg_nnd'. Load address: 0xc2000000 Loading: ################################################################# ################################################################# ########################### done Bytes transferred = 2302152 (2320c8 hex) ## Booting kernel from Legacy Image at c2000000 ... Image Name: Linux-2.6.33-rc4 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2302088 Bytes = 2.2 MB Load Address: c0008000 Entry Point: c0008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Uncompressing Linux... done, booting the kernel. Linux version 2.6.33-rc4 (duyky@duyky-ubuntu) (gcc version 4.3.3 (Sourcery G++ Lite 2009q1-203) ) #8 PREEMPT Tue May 1 21:21:37 PDT 2012 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 CPU: VIVT data cache, VIVT instruction cache Machine: DaVinci DA850/OMAP-L138/AM18xx EVM Memory policy: ECC disabled, Data cache writeback On node 0 totalpages: 32768 free_area_init_node: node 0, pgdat c04a38b0, node_mem_map c04c7000 DMA zone: 256 pages used for memmap DMA zone: 0 pages reserved DMA zone: 32512 pages, LIFO batch:7 DaVinci da850/omap-l138/am18xx variant 0x1 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 Kernel command line: console=ttyS2,115200n8 root=/dev/nfs rw nfsroot=10.1.1.5:/home/duyky/_NFS/_RFS,wsize=1500,rsize=1500 ip=dhcp ig nore_loglevel debug: ignoring loglevel setting. PID hash table entries: 512 (order: -1, 2048 bytes) Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 128MB = 128MB total Memory: 124912KB available (4360K code, 324K data, 164K init, 0K highmem) SLUB: Genslabs=11, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Hierarchical RCU implementation. NR_IRQS:245 Console: colour dummy device 80x30 Calibrating delay loop... 149.50 BogoMIPS (lpj=747520) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok DaVinci: 144 gpio irqs regulator: core version 0.5 NET: Registered protocol family 16 bio: create slab at 0 SCSI subsystem initialized libata version 3.00 loaded. usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb regulator: VDCDC1: 3200 <--> 3300 mV at 3300 mV regulator: VDCDC2: 1750 <--> 3300 mV at 3300 mV regulator: VDCDC3: 950 <--> 1375 mV at 1200 mV regulator: LDO1: 1800 mV regulator: LDO2: 1150 <--> 1300 mV at 1200 mV i2c-gpio i2c-gpio.1: using pins 20 (SDA) and 21 (SCL) vpif vpif: vpif probe success Switching to clocksource timer0_1 musb_hdrc: version 6.0, cppi4.1-dma, otg (peripheral+host), debug=0 Waiting for USB PHY clock good... musb_hdrc: ConfigData=0x06 (UTMI-8, dyn FIFOs, SoftConn) musb_hdrc: MHDRC RTL version 1.800 musb_hdrc: setup fifo_mode 2 musb_hdrc: 8/9 max ep, 3904/4096 memory musb_hdrc: USB OTG mode controller at fee00000 using DMA, IRQ 58 musb_hdrc musb_hdrc: MUSB HDRC host driver musb_hdrc musb_hdrc: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. EMAC: MII PHY configured, RMII PHY will not be functional JFFS2 version 2.2. (NAND) B) 2001-2006 Red Hat, Inc. msgmni has been set to 244 io scheduler noop registered (default) da8xx_lcdc da8xx_lcdc.0: GLCD: Found Sharp_LK043T1DG01 panel Console: switching to colour frame buffer device 60x34 Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x1c42000 (irq = 25) is a 16550A serial8250.0: ttyS1 at MMIO 0x1d0c000 (irq = 53) is a 16550A serial8250.0: ttyS2 at MMIO 0x1d0d000 (irq = 61) is a 16550A console [ttyS2] enabled brd: module loaded loop: module loaded ahci ahci: version 3.0 ahci ahci: forcing PORTS_IMPL to 0x1 ahci ahci: AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode ahci ahci: flags: ncq sntf pm led clo only pmp pio slum part ccc scsi0 : ahci ata1: SATA max UDMA/133 irq 67 NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit) Bad block table not found for chip 0 Bad block table not found for chip 0 Scanning device for bad blocks Bad eraseblock 885 at 0x000006ea0000 Bad block table written to 0x000007fe0000, version 0x01 Bad block table written to 0x000007fc0000, version 0x01 Creating 5 MTD partitions on "davinci_nand.1": 0x000000000000-0x000000020000 : "u-boot env" 0x000000020000-0x000000040000 : "UBL" 0x000000040000-0x0000000c0000 : "u-boot" 0x000000200000-0x000000600000 : "kernel" 0x000000600000-0x000007fc0000 : "filesystem" davinci_nand davinci_nand.1: controller rev. 2.5 console [netcon0] enabled netconsole: network logging started ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ohci ohci.0: DA8xx OHCI ohci ohci.0: new USB bus registered, assigned bus number 2 ohci ohci.0: irq 59, io mem 0x01e25000 hub 2-0:1.0: USB hub found hub 2-0:1.0: 1 port detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. g_ether gadget: using random self ethernet address g_ether gadget: using random host ethernet address usb0: MAC e6:23:ee:97:e6:3e usb0: HOST MAC 5a:ef:c8:bf:93:07 g_ether gadget: Ethernet Gadget, version: Memorial Day 2008 g_ether gadget: g_ether ready musb_hdrc musb_hdrc: MUSB HDRC host driver musb_hdrc musb_hdrc: new USB bus registered, assigned bus number 3 hub 3-0:1.0: USB hub found hub 3-0:1.0: 1 port detected omap_rtc omap_rtc: rtc core: registered omap_rtc as rtc0 omap_rtc: RTC power up reset detected i2c /dev entries driver Linux video capture interface: v2.00 tvp514x 1-005d: tvp514x 1-005d decoder driver registered !! vpif_capture vpif_capture: registered sub device tvp514x-0 tvp514x 1-005c: tvp514x 1-005c decoder driver registered !! vpif_capture vpif_capture: registered sub device tvp514x-1 vpif_capture vpif_capture: VPIF Capture driver initialized usbcore: registered new interface driver uvcvideo USB Video Class driver (v0.1.0) watchdog watchdog: heartbeat 60 sec cpuidle: using governor ladder cpuidle: using governor menu davinci_mmc davinci_mmc.0: Using DMA, 4-bit mode Registered led device: led1 hub 3-0:1.0: activate --> -22 ata1: SATA link down (SStatus 0 SControl 300) Registered led device: led2 usbcore: registered new interface driver usbhid usbhid: USB HID core driver Advanced Linux Sound Architecture Driver Version 1.0.21. usbcore: registered new interface driver snd-usb-audio No device for DAI tlv320aic3x asoc: tlv320aic3x <-> davinci-i2s mapping ok ALSA device list: #0: DA850/OMAP-L138 EVM (tlv320aic3x) TCP cubic registered NET: Registered protocol family 17 Clocks: disable unused emac Clocks: disable unused spi1 regulator_init_complete: incomplete constraints, leaving LDO2 on regulator_init_complete: incomplete constraints, leaving LDO1 on regulator_init_complete: incomplete constraints, leaving VDCDC3 on regulator_init_complete: incomplete constraints, leaving VDCDC2 on regulator_init_complete: incomplete constraints, leaving VDCDC1 on //>> Random MAC addr : >> MAC_ADDR 00 00 00 00 00 00 emac-mii: probed //>> davinci_emac_probe : >> MAC_ADDR 00 12 34 56 78 91 omap_rtc omap_rtc: setting system clock to 2000-01-01 00:00:00 UTC (946684800) mmc0: host does not support reading read-only switch. assuming write-enable. mmc0: new high speed SD card at address 0002 mmcblk0: mmc0:0002 00000 971 MiB mmcblk0: p1 Sending DHCP requests ., OK IP-Config: Got DHCP answer from 0.0.0.0, my address is 10.1.1.14 IP-Config: Complete: device=eth0, addr=10.1.1.14, mask=255.255.255.0, gw=10.1.1.1, host=10.1.1.14, domain=, nis-domain=(none), bootserver=0.0.0.0, rootserver=10.1.1.5, rootpath= Looking up port of RPC 100003/2 on 10.1.1.5 Looking up port of RPC 100005/1 on 10.1.1.5 VFS: Mounted root (nfs filesystem) on device 0:13. Freeing init memory: 164K << Start rcS for System Start-Up>> Start ntpd to get / set time Start inetd Start httpd Start telnetd << Done rcS >> Please press Enter to activate this console. << Start Shell Profile >> Sat May 12 11:18:40 PST 2012 << Done profile >> arm_14:/home % date Sat May 12 11:18:45 PST 2012 arm_14:/home %